HP XP Command View Advanced Edition Software - Manual (Page 153)

Command line interface commands
153
Table 4-54 hostModeOption parameter values and description
hostModeOption
Values Description
7 Specify this value when both of the following conditions are satisfied:
•
The host connection mode is set to Standard (mode 00) or Solaris (mode 09).
•
You want to let the system automatically recognize the reduction and increase in
the number of devices while a SUN host bus adapter is in use.
12 Specify this value when both of the following conditions are satisfied:
•
The host connection mode is set to HP (mode 03).
•
You want to prevent devices to which no paths have been defined from creating a
device file when the HP-UX host is connected.
13 Specify this value when you want to get a SIM notification when the number of
unsuccessful connections between ports exceeds a threshold.
14 Specify this value when both of the following conditions are satisfied:
•
The host connection mode is set to Tru64 (mode 07).
•
You want to use HP TruCluster to set up a cluster on both an XP Continuous
Access Software primary and secondary volume.
NOTE: This value is valid for the XP12000/XP10000/SVS200 only.
15 Specify this value when both of the following conditions are satisfied:
•
The host connection mode is set to AIX (mode 0F).
•
HACMP 4.5 4.5.13 or later, HACMP 5.1 5.1.0.4 or later, or HACMP 5.2 or later is
in use.
19 Specify this value when you are using XP12000/XP10000/SVS200 to register a host
on which VMware is running in a host group.
22 Specify this value when both of the following conditions are satisfied:
•
The host connection mode is set to AIX (mode 0F).
•
VERITAS Cluster Server is in use.
23 Specify this value when you are using XP24000/XP20000 or
XP12000/XP10000/SVS200, and want to shorten the recovery time of the host if data
transfer fails.
24 Specify this value when both of the following conditions are satisfied:
•
The host accesses a volume that exceeds 2 TB.
•
The host OS is one of the following:
○
AIX 5.2 TL08 or later, or AIX 5.3 TL04 or later
○
Windows Server 2003 SP1
○
Red Hat Enterprise Linux AS 4 Update 1 or later
NOTE: OSs other than above cannot access volumes that exceed 2 TB.
NOTE: The maximum size of the volume varies, depending on the file system of the
OS.
NOTE: This value is valid when the DKC microcode version of the
XP12000/XP10000/SVS200 is 50-08-0X-XX/XX or later.
27 Specify this value when you are using XP12000/XP10000/SVS200 and an iSCSI
connection.
Command execution example: In this example, the CLI command modifies the settings for a port
(port number: 16) of a storage subsystem (serial number: 10001, model: XP1024)f. The command: