HP XP Command View Advanced Edition Software - Manual (Page 186)

Command line interface commands
186
Table 4-76 DeleteWWNForLunGroup command parameters
Parameter Name Status Description
portname Optional Port name of the LUN group
NOTE: Specify either port or portname. Do not specify both
parameters at the same time. This might cause an error to occur.
objectid Required Object ID of the LUN group
Specify the objectID obtained from another CLI response. The value is
encoded by the CLI.
wwn Required Comma-separated list of WWNs that exist in the LUN group
Command execution example:
hdvmcli DeleteWWNForLunGroup -o "D:\logs\XP512 DeleteWWNForLUNGroup.log"
"serialnum=10001" "model=XP512" "port=19" "objectid=*****"
"wwn=11.55.77.99.33.00.22.66,AA.AA.AA.AA.AA.AA.AA.AA"
***** : The value is encoded by the CLI.
Command execution result:
RESPONSE:
(Command completed; no data returned)
4-6-13 DeleteWWNGroup
DeleteWWNGroup removes a WWN group from a port (XP512/XP48 subsystem only) (see Table 4-
77 ). The corresponding WWNs are not removed from the port.
A user who has only View permission cannot execute this command. A user to whom a user-defined
resource group is assigned, and who also has Modify permission, can execute this command for
any resources.
NOTE: DeleteWWNGroup is supported by XP512/XP48 storage subsystems only.
Table 4-77 DeleteWWNGroup command parameters
Parameter Name Status Description
serialnum Required Serial number of the port's storage array
model Required Model of the port's storage array
port Optional Port number
NOTE: Specify either port or portname. Do not specify both parameters
at the same time. This might cause an error to occur.
portname Optional Port name
NOTE: Specify either port or portname. Do not specify both parameters
at the same time. This might cause an error to occur.
wwngroup Required Nickname of the WWN group to be deleted from the port
Command execution example:
hdvmcli DeleteWwnGroup -o "D:\logs\XP512 DeleteWwnGroup.log" "serialnum=10011"
"model=XP512" "port=19" "wwngroup=WG"