HP XP Command View Advanced Edition Software - Manual (Page 183)

Command line interface commands
183
Table 4-73 DeleteWWN command parameters
Parameter Name Status Description
serialnum Required Serial number of the port's storage array
model Required Model of the port's storage array
port Optional Port number
NOTE: Specify either port or portname. Do not specify both parameters
at the same time. This might cause an error to occur.
portname Optional Port name
NOTE: Specify either port or portname. Do not specify both parameters
at the same time. This might cause an error to occur.
wwn Required WWN to be deleted from the port
Command execution example:
hdvmcli DeleteWWN -o "D:\logs\XP1024 DeleteWWN.log" "serialnum=10001"
"model=XP1024" "port=0" "wwn=11.22.33.22.44.55.33.11"
Command execution result:
RESPONSE:
(Command completed; no data returned)
4-6-10 DeleteWWNForHostStorageDomain
DeleteWWNForHostStorageDomain removes security for LUNs that are under a specified
HostStorageDomain. The HostStorageDomain must already exist and be secured (see Table 4-74 ).
A user who has only View permission cannot execute this command. A user to whom a user-defined
resource group is assigned, and who also has Modify permission, can execute this command for
any resources.
Table 4-74 DeleteWWNForHostStorageDomain command parameters
Parameter Name Status Description
serialnum Required Serial number of the storage array for the host storage domain
model Required Model of the storage array for the host storage domain
port Optional Port ID of the host storage domain
NOTE: Specify either port or portname. Do not specify both
parameters at the same time. This might cause an error to occur.
portname Optional Port name of the host storage domain
NOTE: Specify either port or portname. Do not specify both
parameters at the same time. This might cause an error to occur.
domain Required Domain ID of the host storage domain
This parameter can be specified in decimal and hexadecimal. If you
specify a hexadecimal number, add the 0x prefix.
NOTE: The execution results are output in decimal.
NOTE: You must specify either domain or domainnickname. Do not
specify both parameters at the same time, as this might cause an error to
occur.