HP XP Command View Advanced Edition Software - Manual (Page 227)

Command line interface commands
227
4-10 Items output as command execution results
This section lists the items that are output when Device Manager CLI commands are executed.
These items are output as attributes of each Device Manager instance. The meaning of items that
have the same name can differ for different instances. When you refer to an output item, check the
instance of the item.
4-10-1 Items output when instance is Alert
The Alert instance is output when the GetAlerts command (see section 4-8-4 ) is executed.
Table 4-102 lists and describes the attributes of the Alert instance.
Table 4-102 Items output when instance is Alert
Attribute Description
number Alert number
type Alert type
One of the following types is output:
•
Server : Device Manager server
•
Trap : SNMP trap from the storage subsystem
source Alert source
The object ID of the storage subsystem is output.
severity Alert severity
One of the following values is output:
•
0 : Unknown
•
1 : No Error
•
2 : Acute
•
3 : Serious
•
4 : Moderate
•
5 : Service
component Component where the alert occurred
For details about the component, see the attribute name of the instance
Component
.
description Alert description (example: Serious error detected on DKU drive.)
actionToTake Action to be taken for the alert (example: Contact Customer Support.)
data Data required to analyze the alert
When the value of type is Trap, the SIM data required by the customer service is
output.
timeOfAlert Time the alert occurred (example: 2003/01/06 20:13:56)
4-10-2 Items output when instance is ArrayGroup
The ArrayGroup instance is output when the following commands are executed:
•
AddVirtualVolume (see section 4-4-7 )
•
GetStorageArray (subtarget=ArrayGroup) (see section 4-4-17-3 )
•
GetStorageArray (subtarget=FreeSpace) (see section 4-4-17-7 )