HP XP Command View Advanced Edition Software - Manual (Page 29)

Setting up command line interface
29
2 Setting up command line interface
This chapter describes the system requirements and startup instructions for Device Manager CLI. It
discusses the following:
•
Requirements for CLI operations (section 2-1 )
•
Java environment settings (section 2-2 )
•
Executing Device Manager CLI commands over HTTPS (section 2-3 )
2-1 Requirements for CLI operations
The following gives requirements for Device Manager CLI operations.
2-1-1 System requirements
The following requirements must be satisfied when you operate the Device Manager CLI:
•
Storage systems
All storage systems must be configured for Device Manager operations. For details about
storage system requirements, see the HP StorageWorks XP Command View Advanced Edition
software Device Manager server installation and configuration guide.
•
Device Manager server
See the HP StorageWorks XP Command View Advanced Edition software Device Manager
server installation and configuration guide for more information on installing and configuring the
Device Manager server.
NOTE: If a firewall is set up between the machine on which Device Manager CLI is running and
the Device Manager server, set the firewall so the port number of the Device Manager server can
be used. The default port number of the Device Manager server is 2001 for non-SSL
communication and 2443 for SSL communication.
•
Device Manager agent
Installation of the Device Manager agent is recommended but not required for Device Manager
operations. When the Device Manager agent is installed, the Device Manager displays the
storage usage rate and file system information. See the HP StorageWorks XP Command View
Advanced Edition software Device Manager agent installation and configuration guide for more
information.
•
Platforms for Device Manager CLI and the Java Runtime Environment
Table 2-1 lists platforms on which Device Manager CLI runs and the requisite Java runtime
environments. In addition, this table also lists the support status of Device Manager CLI in IPv6
environments. The following symbols are used in the table:
○
Y: Device Manager CLI is supported in IPv6 environments.
○
N: Device Manager CLI is not supported in IPv6 environments.