HP XP Command View Advanced Edition Software - Manual (Page 261)

Command line interface commands
261
4-10-29 Items output when instance is
ReplicationControllerPair
The ReplicationControllerPair instance is output when the
GetReplicationControllerPair
command (see section 4-9-4 ) is executed.
Table 4-130 lists and describes the attributes of the ReplicationControllerPair instance.
Table 4-130 Items output when instance is ReplicationControllerPair
Attribute Description
objectID Object ID of ReplicationControllerPair
masterArrayType MCU model
masterControllerID CU number of the MCU
masterEndDevNum Maximum device number among the applicable LUs in the MCU
masterSerialNumber Serial number of the MCU
masterStartDevNum Minimum device number among the applicable LUs in the MCU
remoteArrayType RCU model
remoteControllerID CU number of the RCU
remoteEndDevNum Maximum device number among the applicable LUs in the RCU
remoteSerialNumber Serial number of the RCU
remoteSSID SSID of the RCU
0 is displayed if there is no RCU
remoteStartDevNum Minimum device number among the applicable LUs in the RCU
pairType Type of ReplicationControllerPair
One of the following values is output:
•
0 : Free of the CU (independent)
•
1 : Dependent on the CU
•
-1 : Unknown
4-10-30 Items output when instance is ReplicationGroup
The ReplicationGroup instance is output when the following commands are executed:
•
AddReplication (see section 4-9-2 )
•
DeleteReplication (see section 4-9-3 )
•
GetHost (see section 4-7-6 )
•
ModifyReplication (see section 4-9-5 )
Table 4-131 lists and describes the attributes of the ReplicationGroup instance.
Table 4-131 Items output when instance is ReplicationGroup
Attribute Description
objectID Object ID of the copy group
replicationGroupID Group ID of the copy group