HP XP Command View Advanced Edition Software - Manual (Page 155)

Command line interface commands
155
4-4-22 ModifyPortController
ModifyPortController supports changing characteristics of a PortController (see Table 4-55 ).
A user to whom a user-defined resource group is assigned, and who has only View permission
cannot execute this command.
Table 4-55 ModifyPortController command parameters
Parameter Name Status Description
serialnum Required Serial number of the port controller's storage array
model Required Model of the port controller's storage array
ctrlid Required Number of the port controller
NOTE: Specify either ctrlid or controllername. Do not specify both
parameters at the same time. This might cause an error to occur.
controllername Optional Port controller name
NOTE: Specify either ctrlid or controllername. Do not specify both
parameters at the same time. This might cause an error to occur.
adaptermode Required Mode value of the port controller
Specify either of the following values:
1: Normal
2: High Speed
Command execution example:
hdvmcli ModifyPortController -o "D:\logs\XP1024 ModifyPortController.log"
"serialnum=10001" "model=XP1024" "ctrlid=1" "adaptermode=1"
Command execution result:
RESPONSE:
An instance of StorageArray
.
. (Attributes of StorageArray are omitted here)
.
List of 1 PortController elements:
An instance of PortController
objectID=*****
cluster=1
card=1
controllerID=1
displayName=CHA-1P
mode=1
type=12
***** : The value is encoded by the CLI.
4-4-23 ModifyVirtualVolume
ModifyVirtualVolume assigns and releases assignations between THP volumes (virtual
volumes) and THP pools, and changes the usage threshold rate of THP volumes (see Table 4-56 ).
A user who has only View permission cannot execute this command. A user to whom user-defined
resource groups are assigned, and who also has Modify permission, can execute this command for
any resources.