HP XP Command View Advanced Edition Software - Manual (Page 85)

Command line interface commands
85
Command execution result:
RESPONSE:
(Command completed; empty list returned)
4-4-12 DeletePool
DeletePool deletes a THP pool, and releases the assignations to the pool volumes that made up
the THP pool (see Table 4-25 ).
A user who has only View permission cannot execute this command. A user to whom user-defined
resource groups are assigned, and who also has Modify permission, can execute this command for
any resources.
NOTE: This command can be used only with XP24000/XP20000 storage subsystems.
NOTE: Before you delete a THP pool, you must release all assignations between the THP pool
and the THP volumes (virtual volumes). You cannot delete the THP pool until you release these
assignations. For details about releasing the assignations between the THP pool and the THP
volumes, see section
4-4-23 .
Table 4-25 DeletePool command parameters
Parameter Name Status Description
model Required Model of the storage subsystem
serialnum Required Serial number of the storage subsystem
poolid Required Pool ID
Specify the pool ID of the THP pool to be deleted.
Command execution example: In this example, the DeletePool command deletes the THP pool
whose pool ID is 0 (poolid: 0) from the storage subsystem (serialnum: 15065, model:
XP24000
).
hdvmcli DeletePool -o "D:\logs\XP24000\DeletePool.log" model=XP24000
serialnum=15065 poolid=0
Command execution result:
RESPONSE:
(Command completed; empty list returned)
4-4-13 DeleteStorageArray
DeleteStorageArray removes an HP StorageWorks Disk Array from the Device Manager
management-target, but does not attempt to change the configuration of any storage device (see
Table 4-26 ).
A user to whom a user-defined resource group is assigned and who has only View
permission cannot execute this command.