HP XP Command View Advanced Edition Software - Manual (Page 179)

Command line interface commands
179
Table 4-69 AddWWNForLunGroup command parameters
Parameter Name Status Description
serialnum Required Serial number of the storage array in which the LUN group exists
model Required Model of the storage array in which the LUN group exists
port Optional Port number of the LUN group
NOTE: Specify either port or portname. Do not specify both
parameters at the same time. This might cause an error to occur.
portname Optional Port name of the LUN group
NOTE: Specify either port or portname. Do not specify both
parameters at the same time. This might cause an error to occur.
objectid Required Object ID of the LUN group
Specify the objectID obtained from another CLI response. The value is
encoded by the CLI.
wwn Required Comma-separated list of WWNs to secure the LUN group
Command execution example:
hdvmcli AddWWNForLunGroup -o "D:\logs\XP512 AddWWNForLUNGroup.log"
"serialnum=10001" "model=XP512" "port=19" "objectid=*****"
"wwn=11.55.77.99.33.00.22.66,AA.AA.AA.AA.AA.AA.AA.AA"
***** : The value is encoded by the CLI.
Command execution result:
RESPONSE:
An instance of StorageArray
.
. (Attributes of StorageArray are omitted here)
.
List of 1 Port elements:
An instance of Port
.
. (Attributes of Port are omitted here)
.
List of 1 LUNGroup elements:
An instance of LUNGroup
objectID=*****
name=hp
nickname=hp
List of 2 WWN elements:
An instance of WWN
WWN=11.55.77.99.33.00.22.66
.
. (repeated for other WWN instances)
.
***** : The value is encoded by the CLI.
4-6-6 AddWWNGroup
AddWWNGroup adds a WWN group to the target storage subsystem port, and adds two or more
WWNs to the WWN group (see Table 4-70 ). The maximum number of WWNs in a port WWN group