HP LaserJet 3150 All-in-One Printer series - Manual (Page 171)

EN Resolving control panel error messages 169
Fax Document was
Lost Faxes in memory were lost due to a power
failure. If you set up faxes to be sent at a future
time or to be polled, or if the product
was set to receive faxes to memory,
print a fax log (see page 142) to identify
which ones were lost and then resend
them, or ask them to be re-sent.
Fax Memory Error
#(number 1-5) An error was detected in DRAM. Unplug the power cord from the power
source, wait 10 seconds, and replug in
the power cord.
Try a different power outlet or surge
protector.
Group is Empty, Use
ONE-TOUCH/
SPEED DIAL Appears when you are creating a group-
dial code. Begin adding fax numbers to the group-
dial code. See “Programming group-dial
codes from the control panel” on
page 113.
Input Limit Reached Too many fax numbers were dialed when
trying to send to an ad-hoc group. The maximum number of fax numbers
that can be added to an ad-hoc group is
100. Resend the fax to 100 or fewer
numbers.
Invalid Date or Time An invalid time or date was entered, such
as 25:99 PM or June 35. Re-enter the date and time.
Long Page?
START to Continue The HP LaserJet 3150 product senses a
document over 39 inches (991 mm), such
as a banner, may be feeding through the
document feeder tray or that a paper jam
has occured. If there is no jam, quickly press S TART to
continue. If S TART is not pressed within
a few moments, the HP LaserJet 3150
product assumes a page has jammed
and cancels the job.
If there is a jam, remove it and restart
the job.
If you are sending a fax longer than 39
in (991 mm), you can also use the
Sending long pages (page 30)
procedure.
Memory Full - Send
Unscanned Pages During the fax job the memory filled. All
pages of the fax have to be in memory for
a fax job to work correctly. Only the pages
that fit into memory were sent. Reload the pages that did not send and
send them.
Message Cause Solution