HP Multi-Site Traffic Director sa9200 - Manual (Page 107)

C H A P T E R 6 System Commands
101
trap info Displays the trap receiver list of:
• Trap ID Address
• Trap Community
trap port Specifies the trap port number.
The port number is between 5020 and 65535. Default is 162.
Syntax:
config sys snmp trap port <trap port>
where trap port is the designated number.
trap create Allows you to specify the host to which SA9200 sends SNMP
traps. Up to 10 trap receivers can be created. By default the trap
receiver list is empty, that is, no traps are sent.
Syntax:
config sys snmp trap create <ip address> community
<community string>
where ip address is the IP address of the host to which you
wish to send SNMP traps. community string is sent with all
traps sent to the IP address.
trap delete Deletes a host from the trap receiver list.
Syntax:
config sys snmp trap delete <ip address>
community <community string>
where ip address is the IP address of the host you wish to
delete from the trap receiver list, and community string is an
identifier associated with specified access rights.
Command Description
Config Sys SNMP Commands