HP Multi-Site Traffic Director sa9200 - Manual (Page 99)

C H A P T E R 6 Configuration Commands
93
telnet-sessions
NOTE: If you set the
number of sessions to 0,
you are disabling all future
Telnet sessions to the
SA9200. To reset Telnet,
you must access the device
through the serial port and
login, then change the
Telnet session count from
0, to a number from 1 to 8
Sets the allowable number of concurrent inbound remote CLI
login sessions.
Syntax:
config CLI telnet-sessions <nsessions>
where:
nsessions is the number of allowed sessions (0 to 8). The
default number of sessions is 0. .
timeout
NOTE: Too small of a
timeout value renders the
CLI useless.
Sets or changes the idle timeout period before automatic logout
for CLI sessions. The timeout value can be set to 0, which
specifies no timeout. To set a value, use the range 30 to 65535
seconds.
Syntax:
config CLI timeout <seconds>
where:
seconds is the timeout period in seconds (0, or a range of 30 to
65535). The default is 900 seconds (15 minutes).
Command Description
Config CLI Commands