HP Multi-Site Traffic Director sa9200 - Manual (Page 121)

C H A P T E R 6 DNS Commands
115
enable Enables the ISV group for all services under it. All ISV groups
are enabled by default.
disable Disables the specified ISV group. Services under this ISV group
are not available after disabling.
interval Configures the interval at which metrics are gathered from the
specified service. The default is 30 seconds.
Syntax:
config dns isvgroups <isvname> interval <seconds>
where:
isvname is the name of the service whose metric-gathering
interval you wish to set.
seconds is an integer between 1 and 300 seconds.
timeout Sets the length of timeout waited before assuming the metric
interval has failed. The default is 15 seconds.
Syntax:
config dns isvgroups <isvname> timeout <seconds>
where:
isvname is the name of the agent whose metric-gathering
interval you wish to set.
seconds is an integer between 1 and 300 seconds.
flash-src
NOTE: Any SA9200
designated as an authority
must also be a flash peer to
use flash load balancing.
See config dns zones
<zonename> create-
authority.
Configures the IP address of the peer flash source.
For example:
flash-src 10.1.1.1
flash-port Sets or changes the UDP port number through which flash peers
communicate to each other. The default port number is 2000.
Command Description
Config DNS ISV-Groups Commands