HP Multi-Site Traffic Director sa9200 - Manual (Page 91)

C H A P T E R 6 Global & CLI System Commands
85
dbpr (cont’d) Displays a single VIP- the one associated with host www.foo-
ex.com whose IP address is 10.234.2.2 and is on the load balancer
at 10.168.16.3:1999
-c causes the referral statistics associated with all displayed VIPs
to be cleared following the display.
exit Exits the CLI.
factory-default
NOTE: Only those
parameters set within the
CLI are affected.
Resets the SA9200 to its original factory configuration. Original
factory settings are listed below.
Networking parameters controlled through the Boot Monitor are
not affected by the
factory-default command.
CLI factory settings:
• Entire DNS configuration is deleted.
• SA9200 is set to primary.
• Telnet port is set to 23.
• Prompt is reset to product name.
• Maximum Telnet sessions is set to 0.
• Idle timeout is set to 900 seconds.
• Maximum login attempts is set to 3.
grep Searches for a specified string of characters. See the section
entitled Pipes earlier in this Chapter.
halt Shuts down the SA9200 preparatory to power off. If you wish to
return the SA9200 to operational mode from the halted state, you
must manually reboot using the switch labeled "Reset" on the rear
panel.
help Displays help for the CLI.
history Displays the command history list or recalls a command by index
number from the history list.
Syntax:
history {<n>}
where:
n is the command index number from the history list
Command Description
Global & CLI System Commands