HP Remote Insight Lights-Out Edition II Board - Manual (Page 154)

Scripting, command line, and utility options 154
MSG = "Error Message"/>
MOD_GLOBAL_SETTINGS
This command modifies certain global settings. This command is only valid inside a RIB_INFO block. The
logged-in user must have the configure RILOE privilege, and RIB_INFO must be in write mode. All of these
elements are optional and may be left out. If an element is left out, then the current setting is preserved.
Example:
<RIBCL VERSION="2.0">
<LOGIN USER_LOGIN="adminname" PASSWORD="password">
<RIB_INFO MODE="write">
<MOD_GLOBAL_SETTINGS>
<SESSION_TIMEOUT value="60"/>
<F8_PROMPT_ENABLED value="Yes"/>
<HOST_KEYBOARD_ENABLED value="Yes"/>
<REMOTE_CONSOLE_PORT_STATUS value="3"/>
<POCKETPC_ACCESS value="Yes"/>
<REMOTE_CONSOLE_ENCRYPTION value="Yes"/>
<CIPHER_STRENGTH value="128"/>
<HTTPS_PORT value="443"/>
<HTTP_PORT value="80"/>
<REMOTE_CONSOLE_PORT value="23"/>
<SNMP_ADDRESS_1 value="123.124.125.126"/>
<SNMP_ADDRESS_2 value="Test"/>
<SNMP_ADDRESS_3 value="Test"/>
<OS_TRAPS value="Yes"/>
<RIB_TRAPS value="No"/>
<EMS_SETTINGS value="No"/>
<BYPASS_POWER_CABLE_REPORTING value="No"/>
<CIM_SECURITY_MASK="3"/>
</MOD_GLOBAL_SETTINGS>
</RIB_INFO>
</LOGIN>
</RIBCL>
MOD_GLOBAL_SETTINGS parameters
SESSION_TIMEOUT determines the maximum session timeout value in minutes. The accepted values are
from 0 to 120. If a value greater than 120 is specified, the SESSION_TIMEOUT returns an error.
F8_PROMPT_ENABLED determines if the F8 prompt for ROM-based configuration is displayed during
POST. The possible values are "Yes" or "No."
HOST_KEYBOARD_ENABLED determines if the host keyboard is enabled or disabled. The possible values
are "Yes" or "No."
REMOTE_CONSOLE_PORT_STATUS determines the configuration for the Remote Console port. The valid
values for this setting are: