Alert and trap problems, Netware initialization errors, 177 netware initialization errors – HP Remote Insight Lights-Out Edition II Board User Manual
Page 177
Troubleshooting the RILOE II 177
If you have installed the drivers and agents for the RILOE II, verify that the RILOE II and the management
PC are on the same subnet. You can verify this quickly by pinging the Remote Insight board from the
management PC. See your network administrator for proper routes to access the network interface of the
RILOE II.
Web browser not connecting to the RILOE II IP address
If the Web browser software is configured to use a proxy server, it will not connect to the RILOE II IP
address. To resolve this issue, configure the browser not to use the proxy server for the IP address of the
RILOE II. For example, in Internet Explorer, select View, Options, click Connection Settings, and
then enter the IP address in the Exceptions field.
NOTE: If the RILOE II is using 128-bit encryption, be sure that the client browser supports 128-bit
encryption.
Alert and trap problems
The following sections provide troubleshooting information for common alert and trap errors.
Inability to Receive Insight Manager 7 Alerts (SNMP Traps) from the RILOE II
1.
Be sure that the correct Systems Insight Manager alert types are enabled.
2.
Log on to the RILOE II with administrative access.
3.
Click SNMP Settings on the Administration tab.
4.
Enter the SNMP IP addresses in the SNMP Trap Destination fields.
Server power status reported incorrectly and send test trap not responding
The power status of the server may be reported as off when the server is actually on. This problem may
occur if the server is powered off and then powered back on within four minutes. The following
configuration will cause this error to occur:
•
The supplied DNS server IP address on the Network Settings page is invalid or unavailable.
•
An SNMP trap destination is set as a DNS name is invalid or unavailable.
•
Remote Insight Board SNMP Traps are enabled with no destination address defined.
If the preceding configuration is set, Send Test Trap also will not respond for a period of approximately
four minutes.
To correct this problem, be sure the DNS server specified in Network Settings is correct. If a DNS server is
not on the network, the setting should be 0.0.0.0. Alternately, use IP addresses instead of DNS names
when configuring SNMP trap destinations.
NetWare initialization errors
When a NetWare server is started, each driver loaded in the AUTOEXEC.NCF is executed. If a problem
is found during execution, an initialization error is displayed. The NetWare error messages table
("
) shows potential initialization error messages and
suggested courses of action.