Lan cable connection, Ac power adapter connection – HP Remote Insight Lights-Out Edition II Board User Manual
Page 17
Installing the RILOE II 17
server onboard video. For instructions on disabling the server onboard video, See the documentation
provided with the server.
LAN cable connection
To access RILOE II using TCP/IP across a 10-MB or 100-MB Ethernet network, connect one end of the
LAN cable to the LAN connector on RILOE II to an active network jack.
The green LED indicator that is located close to the AC power adapter connector indicates the speed of
the connection. If the LED indicator is on, then the connection is 100-MB. If the LED is off, then the
connection is 10-MB.
The green LED indicator that is located close to the video connector indicates a link. If the LED is on, then
a connection is established.
AC power adapter connection
When the AC power adapter is connected, RILOE II has access to power that is independent of the main
server power. To increase server manageability, HP recommends connecting the AC power adapter to a
power circuit that is separate from that of the server.
HP ProLiant CL, DL, and ML servers that use the Remote Insight cable (16- or 30-pin) do not require the use
of the AC power adapter.
The HP ProLiant ML330, ProLiant ML330e, and ProLiant DL760 servers require the installation of the
power adapter included in RILOE II kit. For detailed information, See the documentation provided with the
server. For a complete list of servers that require the AC power adapter, See the HP website