HP Remote Insight Lights-Out Edition II Board - Manual (Page 170)

Scripting, command line, and utility options 170
GET_TWOFACTOR_SETTINGS parameters
None
GET_TWOFACTOR_SETTINGS runtime errors
None
GET_TWOFACTOR_SETTINGS return messages
Starting with RILOE II 1.20, users can be authenticated with a digital certificate. Depending on the RILOE
II Two-Factor Authentication settings, the response to GET_TWOFACTOR_SETTINGS will contain different
data.
Examples of GET_TWOFACTOR_SETTINGS return messages are:
Example of a Two-Factor Authentication settings return message with default settings:
<GET_TWOFACTOR_SETTINGS>
<AUTH_TWOFACTOR_ENABLE VALUE="N"/>
<CERT_REVOCATION_CHECK VALUE="N"/>
<CERT_OWNER_SUBJECT/>
</GET_TWOFACTOR_SETTINGS>
Example of a Two-Factor Authentication settings return message when SAN field in the certificate for
directory authentication is enabled:
<GET_TWOFACTOR_SETTINGS>
<AUTH_TWOFACTOR_ENABLE VALUE="Y"/>
<CERT_REVOCATION_CHECK VALUE="N"/>
<CERT_OWNER_SAN/>
</GET_TWOFACTOR_SETTINGS>
MOD_TWOFACTOR_SETTINGS
The MOD_TWOFACTOR_SETTINGS command is used modify the Two-Factor Authentication settings on
the RILOE II. For this command to parse correctly, the MOD_TWOFACTOR_SETTINGS command must
appear within a RIB_INFO command block, and RIB_INFO MODE must be set to write. You must have the
configure RILOE II privilege to execute this command. Changing the value of
AUTH_TWOFACTOR_ENABLE will cause the RILOE II to reset in order for the new setting to take effect.
NOTE: The GET_TWOFACTOR_SETTINGS and MOD_TWOFACTOR_SETTINGS commands are supported
with iLO firmware version 1.80 and above and with iLO 2 firmware version 1.10 and above. iLO 1.80
requires CPQLOCFG version 2.24, and iLO 1.10 requires CPQLOCFG version 2.25.
A Trusted CA Certificate is required for Two-Factor Authentication to function. The RILOE II will not allow
the AUTH_TWOFACTOR_ENABLE setting to be set to Yes if a Trusted CA certificate has not been
configured. Also, a client certificate must be mapped to a local user account if local user accounts are
being used. If the RILOE II is using directory authentication, client certificate mapping to local user
accounts is optional.
To provide the necessary security, the following configuration changes are made when Two-Factor
Authentication is enabled:
• Remote Console Data Encryption: Yes (This will disable telnet access)
• Enable Secure Shell (SSH) Access: No
• Serial Command Line Interface Status: Disabled