Ag Leader PFadvantage Harvest & Application Operators Manual - Manual (Page 120)

Direct Drive – Accu-Rate PFadvantage
Application Rate Mode Ag Leader Technology
September 2003 2-108
Manual Speed: Set this to your average speed if you are
using manual speed in place of your radar or GPS ground
speed source.
Manual Speed: Normally this should be set to OFF. The
only reason to set this to ON is if you can not get ground
speed from your radar or GPS or you want to run the drive
in a stationary position.
3. Press EXIT key to return to screen with ADVANCED
SETTINGS key. Press the ADVANCED SETTINGS key.
Target Rate Outside Field: This only pertains to using a
target file.
Set to ZERO if want rate outside field to be zero.
Set to USE LAST if want rate to be the last rate used at the
time the vehicle is detected outside the field. This is
useful when experiencing problems with the vehicle being
falsely detected outside of the field during the outside
pass.
Set to TGT DEFAULT if want rate outside field to be the
default rate stored in the target rate file.
Controller Time Delay: Set to seconds.
Actual Rate Units: Ignore this setting.
Log Actual Rate: Set to YES to log actual rate to card. Set
to NO, otherwise.