Ag Leader PFadvantage Harvest & Application Operators Manual - Manual (Page 169)

PFadvantage Logging Map Data on Card
Ag Leader Technology All Modes
September 2003 4-19
Formatting Card The memory card must be formatted with a DOS format. You can format
the card using the PFadvantage or your computer and card reader ( using
Windows 3.1 or 95). Refer to the instructions for formatting a card in the
Card Setup section.
IMPORTANT: Formatting a card erases all data on the card.
Copying Data to
Log File IMPORTANT: Data must be copied to each log file before you read
the card into your computer. The monitor automatically copy copies
data to the card upon shutdown.
To copy memory to log files that are not set as the current log file, press the
SETUP key and CARD key. Press the SHOW FILES key and select one of
the log files. Press the FILE OPTIONS key and press the COPY TO FILE
key.
At the card setup screen, press the COPY TO CARD key to copy memory
to the file set as the log file (this is the same copy to card function that you
are prompted to do during shut down).
Logging Data to a
Memory Card When the monitor logs data to a memory card, a small arrow that points to
the memory card symbol at the top right corner of the display appears.
Operating Mode Condition to start logging to card
Grain Harvest Mode
Grass Harvest Mode Combine engaged (elevator speed must be above
250 rpm) and the monitor is either counting area
or has grain flow.
Application Rate Mode Application equipment engaged.
Site Verification Mode Area count switch on (do not need ground
speed).
Checking Free
Space on Card To check the percent of space free on the card display CARD INFO. When
the amount of time left on the card is exactly four, three, two, and one
hours, the monitor double-beeps warning you that card is almost full.
* * *