Ag Leader PFadvantage Harvest & Application Operators Manual - Manual (Page 166)

Logging Map Data on Card PFadvantage
All Modes Ag Leader Technology
September 2003 4-16
Introduction The PFadvantage reads position information from the internal GPS receiver
and can record data for mapping. To save GPS data, you must use a
memory card. You must use a mapping software to download and archive
data from a memory card.
IMPORTANT: You must copy memory to every log file you create
before you read the card into your computer.
Memory Card
Requirements The following characteristics are required of memory cards you intend to
use with the monitor:
Card Type Sizes Specifications
AG LEADER
ATA Flash card
2 to 32 megabytes (max)
Type 1 or 2 PCMCIA
68-pin connection
200 ns speed rating
IMPORTANT: AG LEADER ATA Flash cards are the only brand of
ATA Flash cards that are guaranteed to work in the PFadvantage.
Note: 32 MB AG LEADER ATA Flash cards are available from your Ag
Leader Technology dealer.
Setting Monitor to
Log to Card Press the SETUP key and CARD key to view the card setup screen. Set the
logging device to a card and select or create a log file.
If you turn the monitor on or start the combine separator without a card in
the monitor and the monitor is set to log to a card, the monitor will display
“INSERT CARD OR PRESS CANCEL”. If you press the CANCEL key,
the message will reappear if the separator is engaged. To continue using the
monitor without a card, disengage the separator, shut off the monitor and
turn it back on again and set the logging device equal to none.