Ag Leader PFadvantage Harvest & Application Operators Manual - Manual (Page 9)

PFadvantage General
Ag Leader Technology
September 2003 1-7
Area Count Switch The area count switch manually turns on and off area counting. When the
switch is in the up position area is counting. When the switch is in the
down position, area is not counting. The monitor will display either
“AREA ON” or “AREA OFF” on the bottom right corner of the display to
indicate the status of area counting.
Connectors The PFadvantage has six connectors on the back of the console. The large
25-pin connector is for power and sensor connections. The AUX 1 port is
for connecting to a GPS receiver. The three 9-pin RS-232 ports (Port 1, Port
2, Port 3) are for connecting to planter or fertilizer or sprayer controller or
any other GPS compatible device. The AUX 2 port is for additional
input/output signals.
Figure 3 Rear of PFadvantage
Port 3 Port 2 Port 1
25-Pin
Connector
AUX Port 1
(GPS)
AUX Port 2