Ag Leader PFadvantage Harvest & Application Operators Manual - Manual (Page 223)

PFadvantage Troubleshooting
Ag Leader Technology Harvest Mode
September 2003 6-5
Moisture is
inaccurate.
Dry moisture is set
incorrectly.
Display INST MOIST on the screen of the
PFadvantage to show the moisture. If it is
incorrect, see “Incorrect Moisture” in this section.
Press MENU, SETUP, and GRAIN. Select the
grain type being harvested by using the up/down
arrow keys. Press EDIT SETTINGS. Check the
dry moisture value (percent moisture that dry
bushels are reduced to. e.g. 13% for soybeans,
15.5% for corn). Use the up/down arrow keys to
select the DRY MOISTURE line, then press
EDIT. Use the up/down arrow keys to set the dry
moisture to the correct value for the grain type
being harvested. The monitor corrects the yields
of previous loads harvested of that grain type.
The load you are
harvesting is set on
the wrong grain type. It is not possible to change grain type on an
existing load. If an incorrect grain type has been
selected, the entire field will need to be changed to
the correct grain type. The load with the wrong
grain type will remain in memory. There can be
more than one-grain type for each field.
The top shaft of the
grain elevator was
adjusted during
harvest to tighten the
elevator chain. Adjusting the top shaft of the grain elevator
changes how the grain hits the flow sensor, and
calibration becomes inaccurate. You must change
to a different grain type and recalibrate the weight.
IMPORTANT: Use the lower elevator adjuster
to tighten the elevator chain, instead of
adjusting the top shaft. Make sure the top shaft
is adjusted so there is ½ in. or less clearance
between the tip of the paddle and the top of the
elevator housing.