Ag Leader PFadvantage Harvest & Application Operators Manual - Manual (Page 152)

Fields and Loads PFadvantage
All Modes Ag Leader Technology
September 2003 4-2
Recommendations All the information recorded by the PFadvantage must be recorded in a
field and load. The field and load that the monitor is set on is found on the
top line of the main operating screen.
Fields
You should at least create all the fields and name them before you begin to
use the PFadvantage. The monitor will use the same set of fields you
create for each operating mode (harvest mode, application rate mode, site
verification mode) of the monitor. You can create and name your fields
using any operating mode. You should choose field names that you can use
year after year.
Loads
It also recommended to create and name loads within fields before you use
the PFadvantage. Each operating mode of the PFadvantage will have its
own set of loads for each field (except, currently site verification loads are
the same as harvest loads).
Definition:
Load: A load is used to subdivide a field into smaller sections. The
monitor load is not associated with the combine tank, wagon, or truck load.
Field
Load