Ag Leader PFadvantage Harvest & Application Operators Manual - Manual (Page 207)

PFadvantage Boundary
Ag Leader Technology All Modes
September 2003 4-57
Step Action
1 Position the vehicle at a starting point on the outside of the field.
2 Press START BOUNDARY key and drive the outside edge of the
field.
3 Use the PAUSE/CONTINUE feature to drive around an obstacle
(wet spot) without including the path around the obstacle in the
boundary map. When you reach the obstacle, press the PAUSE
key. Drive around the obstacle and press CONTINUE key. The
PF will draw in a straight line across the void area in the
boundary map.
4 When you have completed driving the boundary of the field, press
the STOP BOUNDARY key. Then press the SAVE
BOUNDARY key.
NOTE: You should drive back to the starting point before
pressing STOP BOUNDARY key. If you do not, the area
calculated for the field may be inaccurate.
5 Press EXIT key and repeat above steps for other fields. Refer to
the gridding instructions to grid the field.
BOUNDARY SETUP DG
FIELD NAME
SMITH
042.0186450 N
093.6337050 W
GROUND SPEED
21.3
mph
AREA
N 19.737 acres
SAVE
BOUNDARY
CANCEL
IMPORTANT: The Boundary and Grid screens are the only
location where you can view the FIELD AREA information. If you
come back to review information, DO NOT SAVE GRID OR
BOUNDARY AGAIN. If you do this you will lose the boundary
for this field. After reviewing the information, press EXIT key.
***