E figure 6-15 ), 6 - operation – MagTek EC2000 99875600 User Manual
Page 37
6 - Operation
ExpressCard 2000| Instant Issuance Card Personalization System | User Installation and Operation Manual
Page 37
Figure 6-15 – Removing Card Stock Hopper
a) Press down on the hopper release button (labeled with a yellow arrow) near the bottom of the
hopper. The hopper will move away from your finger, toward its release position.
b) Gently push the hopper all the way to its release position.
c) Lift the hopper and remove it from the EC2000.
6) Open the hopper as follows (see Figure 6-16):
Figure 6-16 - Opening Card Stock Hopper
a) Turn the hopper around so its clear loading door is facing you.
b) Slide the gray door release lever, located at the top of the door, to the right and hold it.
c) Pull the door toward you so it swings open.
7) Remove the card weight from the hopper.
8) If you are changing the type of card stock in the hopper or are packing the EC2000 for transport,
remove all existing card stock from the hopper.
9) Repeat the procedure for any other hoppers you want to unload.
Load card stock into hoppers as follows:
1) Obtain the card stock you will be loading.