MagTek EC2000 99875600 - Manual (Page 46)

6 - Operation
ExpressCard 2000| Instant Issuance Card Personalization System | User Installation and Operation Manual
Page 46
Figure 6-26 - Putting Foil Roll On Spool Assembly
11) Place the orange core of the new roll on the orange spool, being careful to thread the foil under the
two foil guide pins as shown in Figure 6-26.
12) Rotate the orange core until you can press it firmly onto the orange spool. Continue rotating until the
foil is tight across the guide pins as shown in Figure 6-27.
Figure 6-27 - Re-inserting the Tipper Foil Spool Assembly
13) Place the foil spool assembly back into the EC2000 foil tipper, carefully threading the foil under the
tipper heater. Press firmly until you feel a click. If the tipper foil spool assembly does not click
into place, rotate the orange spool a bit and try again.
14) Close and secure the top access door.