Sony DPP-FP70 - Manual (Page 16)

16 GB
The frame is fixed in the current
position.
To change the size of the
adjustment frame
Press g/G to select
(Enlarge) or
(Reduce) and press ENTER.
Each time you press ENTER, the
frame becomes larger or smaller.
You can also enlarge or reduce the
size by pressing (zoom in) or
(zoom out) buttons on the printer.
Tip
Make the size of the adjustment frame two
to seven times as large as the eye size.
4
Press g/G to select and press
ENTER.
The range of red-eye correction is
enlarged.
5
Press ENTER.
The adjustment takes effect.
The Red-eye correction menu is
displayed.
To make a red-eye correction for other
eyes, repeat steps 3 to 5.
6
Press g/G to select and press
ENTER.
The Edit menu is displayed again.
To reset the adjustment
Press CANCEL in step 5 instead of
ENTER. The red-eye correction is
canceled and the window of step 2 is
displayed.
Tip
To print the image previewed, press PRINT
(page 17).
Correcting the red-eye
phenomenon
When pressing AUTO TOUCH-UP cannot
reduce the red-eye phenomenon of a
subject shot by flash, you can adjust it
manually.
Note
If you perform additional editing, such as
enlarging, reducing the image size, rotating or
moving an image, after the red-eye correction,
the red-eye correction may not take effect.
Perform the red-eye correction after these
editorial operations.
1
Display the Edit menu (page 12).
2
Press g/G to select (Red-eye
correction) and then press ENTER.
The adjustment frame appears on the
image, which indicates the range for
red-eye correction.
Adjustment frame
3
Adjust the position and size of the
adjustment frame.
Make the red-eye correction for the
right and left eyes separately.
To move the adjustment frame
1 Press g/G to select (Move) and
press ENTER.
2 Move the frame with g/G/f/F.
The frame moves in the selected
direction.
3 Press ENTER.