IPricot IPR-S1000 - Manual (Page 11)

Installing the IPR-S1000
6
Making the connection
Refer to the following illustration to correctly locate the different connectors.
Connect the satellite antenna using a
type F connector.
Note: Make sure the cable is screwed
and secured by tightening the
connector.
Connect the parallel port.
Connect the Ethernet cable with a Shielded Twisted Pair.
Connect the console port.
Connect the serial port.
Insert the Flash card.
Note: Do not extract the card when the power is ON.
- Link AC power cable to the right socket.
- Plug it into the electrical power supply.
After a complete connection, turn the unit power ON.
2. Starting up the IPR-S1000
Read carefully the following procedure to start up the IPR-S1000
successfully.
1) Make sure you have inserted the MMC, and connected the cables.
2) The IPR-S1000 boots up. A progression bar appears on the unit’s
front Liquid Crystal Display (LCD).
Note: The progression bar grows from left to right indicating that the
boot process is evolving normally.
3) After the boot, the unit will display three basic screens on the LCD.
3.Making an initial configuration of the
IPR-S1000
The following configuration will be done using the front buttons of the
IPR-S1000 (LCD interface). However, you can also configure the IPR-
S1000 via the Web or Telnet interface after having set the IP address
and the default router.
1) To access the MAIN menu, press on the «right» arrow.
2) In the MAIN menu, select «1. Set config».
3) Enter that menu by pressing the «right» arrow.