IPricot IPR-S1000 - Manual (Page 87)

Configuring the IPR-S1000
82
display_which_bytes: The number of displayed octets for each packet.
display_which_pkts: The interveal of packages between two postings.
ftp_addr: Access parameters to FTP server which will store TS flow. Necessary
only if FTP is selected.
ftp_login: Access parameters to FTP server which will store TS flow.
Necessary only if FTP is selected.
ftp_passwd: Access parameters to FTP server which will store TS flow.
Necessary only if FTP is selected.
ftp_path: Access parameters to FTP server which will store TS flow. Necessary
only if FTP is selected.
ftp_port: Access parameters to FTP server which will store TS flow. Necessary
only if FTP is selected.
mode_ftp: Selects the FTP mode of analysis.
mode_hexa: Screen select mode (hexadecimal format).
mode_hexaline: Screen select mode (hexaline format).
mode_hexdump: Screen select mode (hexdump format).
mode_stat: Displays statistics only, not packets.
pid_list: This mandatory field must be filled in by a list of Program stream
IDentifier (PID). The PID minimum value is 0 and its maximum value is 8191.
pkt_count: The program will stop after receiving this number of TS packets.
timeout: The program will stop after this number of seconds.
Note: With the Shell interface it is possible not to set a timeout nor a
packet count limit. The user can then stop the program at any time
using CTRL C.
With the read login:
auth (Authentication)
Allows to change the authentication level, i.e to switch to the public,
read or write level. A password is needed only when switching to a
more restricted level.
read: Allows to read the whole IPR-S1000 set up. The user cannot configure the
IPR-S1000.
write: Allows a complete configuration access, and allows to change the set up
parameters.
bye
Allows to exit the shell.
dvb (Digital Video Broadcasting)
Real-time access to the DVB interface.
dlevel: Digital level in percent.