IPricot IPR-S1000 - Manual (Page 98)

Configuring the IPR-S1000
93
that the SNMP agent will use to send traps.
syslog.active
Activation of the syslog service.
syslog.config
List of the options that allows to filter the messages of the IPR-S1000
log.
udlr.active
Activation of UDLR service.
udlr.dtcp_group
The multicast group in which DTCP information are received.
udlr.dtcp_nofeed_router
A default gateway which is installed when the DTCP feed is lost.
udlr.dtcpd
Activation or not of DTCP service.
udlr.feeds
The list of UDLR feeds. If udlr.dtcpd is activated, the list is automatically
filled out according to the received information.
udlr.return_type
The type of route that allows to join the feed (either modem, or router).
udlr.router
When router is activated, the UDLR key router contains the gateway to
reach the feed.
IV. The SNMP interface
SNMP interface offers another possibility to configure the IPR-S1000.
SNMP is a protocol used to carry out network management. It allows to
control a remote network by questioning the stations (which are part of
the network), on their state and modify their configuration. The SNMP
protocol also allows to operate control tests and observe various
information related to the emission of data.mation.
IPricot DVB MIB can be downloaded on the Web interface.