IPricot IPR-S1000 - Manual (Page 90)

Configuring the IPR-S1000
85
count: The number of ECHO_REQUEST.
numeric: Allows to display IP addresses.
timeout: Lifetime of the request.
verbose: Allows to display all received ICMP packets.
ppp (Point to point protocol)
Acts on PPP process.
close: Allows to force, on request, the closing of the session.
isstarted: Allows to know if PPP service is launched. It automatically launches
out when a road borrows the PPP interface.
isup: Allows to know if PPP session is active. If active, allows to know
negotiated IP addresses.
pptp (point to point tuneling protocol)
PPTP module - VPN over PPTP.
close: Allows to force, on request, the closing of the session.
isstarted: Allows to know if PPTP service is launched. It automatically launches
out when a road borrows the PPTP interface.
isup: Allows to know if PPTP session is active. If active, allows to know
negotiated IP addresses.
quit
Allows to exit the shell.
spectrum
Spectrum analyser.
syslog
Displays system messages. To stop the flow, press CTRL C.
system
System action.
autoupdate: Allows to install or delete a new firmware received by the satellite
link.
date: Displays the current time and date.
kernelclean: Allows to delete the previous firmware.
kernelcontents: Displays the firmware contents.
kernelstate: Displays the number of firmware present on the Flash Card.
kernelswap: Allows to switch from the current firmware to the previous one.
packages: Displays the list of installed packages (software) and their version
numbers.
reboot: Allows to restart the IPR-S1000.
tftpget: Allows to retrieve a kernel or a profile from the specified TFTP server.