IPricot IPR-S1000 - Manual (Page 13)

Installing the IPR-S1000
8
Frequency
The number of times an electromagnetic wave (the DVB carrier) goes
through its complete cycle in one second of time.
1) In the «1. Set config» menu, select «11. DVB».
2) Enter that menu by pressing the «right» arrow.
3) With the «down» arrow, select «112. Frequency», and enter that
menu by pressing the «right» arrow.
4) Enter a value using the same method that you used to set the IP
address.
Note: The frequency must be bounded by LNB limits, otherwise the
value will be rejected.
5) Confirm the value by pressing the «down» arrow.
Polarization
A technique used by the satellite designer to increase the capacity of
the satellite transmission channels by reusing the satellite transponder
frequencies.
1) In the «1. Set config» menu, select «11. DVB».
2) Enter that menu by pressing the «right» arrow.
3) With the «down» arrow, select «115. Polarization», and enter that
menu by pressing the «right» arrow.
4) With the «+» or «-» key, select a polarization type.
5) Confirm the selection by pressing the «down» arrow.
Bauds
The symbol rate of the satellite link.
1) In the «1. Set config» menu, select «11. DVB».
2) Enter that menu by pressing the «right» arrow.
3) With the «down» arrow, select «113. Bauds», and enter that menu
by pressing the «right» arrow.
4) Set a value (Baud rate) using the same method that you used to set
the IP address.
5) Confirm the value by pressing the «down» arrow.
FEC
A technique for improving the robustness of data transmission.
1) In the «1. Set config» menu, select «11. DVB».
2) Enter that menu by pressing the «right» arrow.
3) With the «down» arrow, select «114. FEC», and enter that menu by
pressing the «right» arrow.
4) With the «+» or «-» key, select «Auto».
5) Confirm the selection by pressing the «down» arrow.