IPricot IPR-S1000 - Manual (Page 12)

Installing the IPR-S1000
7
IP address
In the most widely installed level of the Internet Protocol (IP) today, an
IP address is a 32-bit number that identifies each sender or receiver of
information that is sent in packets accross the Internet.
1) In the «1. Set config» menu and with the «down» arrow, select «12.
Ethernet».
2) Enter that menu by pressing the «right» arrow.
Note: The «left» and «right» arrows allow you to scroll one by one
the digits of the IP address. The «+» and «-» keys allow you to
increment or decrement the digit by one. The «down» arrow allows
you to confirm, whereas the «up» arrow allows you to cancel.
3) Select «121. IP address».
4) Enter that menu by pressing the «right» arrow.
5) Set the IP address and the network mask (the IP address specified
will be bound to the Ethernet port of the IPR-S1000).
6) Confirm the IP address by pressing the «down» arrow.
Default router
A router which allows you to reach another network.
1) In the «1. Set config» menu and with the «down» arrow, select «13.
IP».
2) Enter that menu by pressing the «right» arrow.
3) With the «down» arrow, select «138. Default route».
4) Enter that menu by pressing the «right» arrow.
5) The default route is displayed on the LCD. To modify the default
route, press the down arrow.
6) Set the default router IP address using the same method that you
used to set the IP address.
7) Confirm the default router IP address by pressing the «down»
arrow.
LNB (Low Noise Block)
Hardware device for converting and amplifying a band of satellite
signals from a high frequency (Ku band for ewample) into a lower
frequency (L band for example).
1) In the «1. Set config» menu, select «11. DVB».
2) Enter that menu by pressing the «right» arrow.
3) Select «111. LNB», and enter that menu by pressing the «right»
arrow.
4) With the «+» or «-» key, select a band.
5) Confirm the selection by pressing the «down» arrow.