Festo Кабели и принадлежности - Manual (Page 26)

2. Fitting
2−4
Festo P.BE−SPC200−COM−CANDN−EN en 0511a
Fitting the modules
Fit the modules into the rack as follows:
1. Switch off first the compressed air supply and then the
operating voltage supply.
2. If necessary, remove the blanking plate.
3. Hold the module by the front plate and push it into the
guide rail. Make sure that the modules are not tilted when
they are pushed in and that the components on the
printed circuit board are not damaged.
4. Make sure that the plugs on the terminal strips are
correctly aligned. Then gently push the module in
completely. The locking levers will then lock automatically.
1
Direction for
unlocking
2
Locks
automatically
3
Locking lever
4
Front plate of the
module
5
Terminal strip
6
Guide rail
1
2
3
4
2
1
5 6
Fig. 2/1: Fitting the modules