Festo Электроцилиндр - Manual (Page 11)

1 Safety and requirements for product use
Festo – GDCP-CMMO-ST-EA-SY-EN – 1301a – English 11
1.2 Requirements for product use
• Make this documentation available to the design engineer, installer and personnel responsible for
commissioning the machine or system in which this product is used.
• Make sure that the specifications of the documentation are always complied with. Also consider the
documentation for the other components and modules.
• Take into consideration the legal regulations applicable for the destination as well as:
– regulations and standards
– regulations of the testing organizations and insurers
– national specifications
1.2.1 Technical requirements
General conditions for the correct and safe use of the product, which must be observed at all times:
• Comply with the connection and environmental conditions specified in the technical data of the
product ( appendix A.1) and of all connected components.
Only compliance with the limit values or load limits permits operation of the product in accordance
with the relevant safety regulations.
• Observe the instructions and warnings in this documentation.
1.2.2 Qualification of the specialists (requirements for the personnel)
The product may only be placed in operation by a qualified electrotechnician who is familiar with:
– installation and operation of electrical control systems
– the applicable regulations for operating safety-engineered systems
– the applicable regulations for accident protection and industrial safety
– the documentation for the product