Festo Электроцилиндр - Manual (Page 99)

6 Diagnostics
Festo – GDCP-CMMO-ST-EA-SY-EN – 1301a – English 99
Table of error messages
31h CVE connection Can be parameterised as: E/-/-
Diagnostic memory: optional
A connection error has occurred during "Control via Ethernet" (CVE).
• Check the connection: plug disconnected, cable lengths observed, shielded cable used, screening
connected?
– Acknowledgement option: Error can only be acknowledged after eliminating the cause.
Parameterisable error response(s): B, C, D, E, F, G
32h FCT connection with master control Can be parameterised as: E/-/-
Diagnostic memory: optional
Connection to the FCT has been interrupted.
• Check the connection and perform a reset if necessary.
– For parameterisation as an error: The error can only be acknowledged after eliminating the cause.
Parameterisable error response(s): B, C, D, E, F, G
33h Output stage temperature warning Can be parameterised as: -/ W/I
Diagnostic memory: optional
Temperature of output stage increased.
• Check cylinder sizing.
• Check motor and cabling for short circuits.
• Check the mechanics for sluggishness.
• Reduce the ambient temperature, improve heat dissipation.
– For parameterisation as a warning: The warning disappears if the temperature is back below the
danger threshold.
34h Save Torque Off (STO) Can be parameterised as: E/W/I
Diagnostic memory: optional
The “Safe Torque Off” safety function has been requested.
• Please observe the separate documentation for the STO function.
– For parameterisation as an error: The error can be acknowledged.
Parameterisable error response(s): 0
– For parameterisation as a warning: The warning disappears if the STO is no longer requested.
37h Standstill monitoring Can be parameterised as: -/ W/I
Diagnostic memory: optional
The actual position is outside the downtime window. Parameterisation of the window may be too
narrow.
• Check parameterisation of the downtime window.
– For parameterisation as a warning: The warning disappears if the actual position is within the
standstill window again or a new record has been started .