Festo Электроцилиндр - Manual (Page 94)

6 Diagnostics
94 Festo – GDCP-CMMO-ST-EA-SY-EN – 1301a – English
Table of error messages
14h Negative direction locked Can be parameterised as: E/-/-
Diagnostic memory: optional
A limit switch error or a software limit position error has occurred and subsequently a movement in
the blocked direction has been initiated.
• Check the target data.
• Check positioning area.
• This error can only be acknowledged if the drive is within the valid movement range. If necessary,
start a corresponding position set or move the drive by using the jog function. Movements in a
negative direction are blocked.
– Acknowledgement option: Error can only be acknowledged after eliminating the cause.
Parameterisable error response(s): A, B, C, E, F
15h Output stage temperature exceeded Can be parameterised as: E/-/-
Diagnostic memory: optional
The permissible limit value for the output stage temperature has been exceeded. The output stage is
possibly overloaded.
• This error can only be acknowledged if the temperature is within the permissible range.
• Check cylinder sizing.
• Check motor and cabling for short circuits.
• Check the mechanics for sluggishness.
• Reduce the ambient temperature, improve heat dissipation.
– Acknowledgement option: Error can be acknowledged.
Parameterisable error response(s): A, B, C, D
16h Output stage temperature too low Can be parameterised as: E/-/-
Diagnostic memory: optional
The ambient temperature is below the permissible range.
• Increase the ambient temperature. This error can only be acknowledged if the temperature is
within the permissible range.
– Acknowledgement option: Error can be acknowledged.
Parameterisable error response(s): A, B, C, D
17h Logic voltage exceeded Can be parameterised as: E/-/-
Diagnostic memory: optional
The logic power supply monitor has detected an overvoltage. This is either due to an internal defect
or an excessive supply voltage.
• Check external supply voltage directly on the device.
• If the error is still present after a reset has been conducted, it means there is an internal defect
and the device has to be replaced.
– Acknowledgement option: Error can be acknowledged.
Parameterisable error response(s): A, B