Konica Minolta bizhub C200 - Manual (Page 62)

C200 4-20
Transmitting data 4
2
Note
For details on the network settings, refer to the User’s Guide [Network Administrator].
If the optional fax kit has not been installed, [Address] appears instead of [Dial].
!
Detail
If settings have been specified for "SMTP Authentication User Name" and "SMTP Authentication
Password" on the machine receiving the IP address fax, specify the SMTP authentication user name
and SMTP authentication password on the machine sending the fax.
If SMTP authentication has been enabled with the software switch settings, [SMTP Authentication]
appears. Touch this button to specify the SMTP authentication user name and SMTP authentication
password.
For details on specifying the software switch settings, refer to the User’s Guide [Network Administrator].
4.3.9 Dial - IP Relay
Using the keypad, type in the fax number of the last destination.
- Tone: If pulse dialing is being used, touch this button to send a push-button tone. This is used when a
fax information service is being used. "T" appears in the screen.
- Pause: Touch this button to insert a pause when dialing. Touch the button once to insert a 1-second
pause. "P" appears in the screen.
- Add: Touch this button to specify an additional destination.
Relay Dest.
Select the device to perform the transmission relay, and then touch [OK].