Konica Minolta bizhub C200 - Manual (Page 61)

C200 4-19
Transmitting data 4
2
Note
For details on registering domain names, refer to "One-Touch/Box Reg. - Domain Name" on
page 8-22 .
If the optional fax kit has not been installed, [Address] appears instead of [Dial].
Scanning Mode
With Internet faxing, when the fax is sent using a transmission size, transmission resolution or coding method
that is not supported by the receiving device, it may not be possible for the recipient to view the received
data. If the maximum values are specified, the data is sent with those previously specified settings, even if
settings unsupported by the receiving device were specified.
!
Detail
If the image data is too large, there will be a large load on the network. In addition, communication may
not be possible, depending on the network environment.
To specify the desired setting for each parameter, select the corresponding parameter, and then
change the setting.
Some images cannot be viewed on the recipient’s computer, depending on the encoding method.
Selecting "MH" increases the possibility that the image can be viewed.
The size of the encoded data depends on the image data. However, data amount for the encoding
methods generally increase as follows: MMR, MR, MH.
4.3.8 Dial - IP Addr. Fax
Type in the destination of the IP address fax.
- Host: A host name can be typed in. The DNS settings (specified from the Network Setting screen) must
be specified first.
- Port: Using the keypad, type in the port number to be used. (Range: 1 to 65535)
- Add: Touch this button to specify an additional destination.
Parameter Description
TX Size (Max.) Select the maximum original size compatible with the recipient’s machine.
TX Resolution (Max.) Select the maximum resolution compatible with the recipient’s machine.
Coding Method Select the coding method compatible with the recipient’s machine.