Konica Minolta bizhub C550 - Manual (Page 486)

Appendix 12
C550 12-10
Pause A temporary break in dialing. In this machine, each pause creates a one sec-
ond break during dialing.
Polling This is a function for sending an original loaded on the machine or stored in
the memory when requested by the recipient.
Memory This is a location where data is temporarily stored. The memory is used when
communication is specified or temporarily stored original is saved.
Memory over-
flow A condition where the fax memory becomes full while scanned originals or
temporarily stored originals are saved.
Memory trans-
mission This is a procedure for starting a fax transmission after an original is scanned
and stored in the memory. If memory transmission is used, the total number
of pages are automatically printed in the page number of the transmission
source information and an image of the first page of the sent original is print-
ed in the transmission report. However, the memory may become full if there
are many pages of the original or if the data is large due to finely detailed im-
ages.
Scanning The operation of optically scanning the original and converting it to image da-
ta.
Scanning size This is a function to specify the scanning size of an original and transmitting
it. If the width of the paper in the recipient’s fax machine is smaller than that
of the transmitted original, the fax is normally reduced when it is printed. If
you do not wish to reduce the fax, specify an original size that is same as the
size of the paper in the recipient’s fax machine in order to send the fax at its
original size.
Redial This is a function for dialing a fax number again after waiting for a specified
length of time, such as when the recipient’s line is busy.
You can select either to redial manually or to redial automatically the number.
Binding Position This is a function for specifying the binding position of a double-sided origi-
nal sent using the ADF. There is top/bottom binding, where the binding po-
sition is at the top (or bottom) of the original, and there is left/right binding,
where the binding position is at the left (or right) of the original and the top
and bottom of the second side of the original differ.
Frame Erase This is a function to erase the black shadow around the original and then
transmitting the fax, for example, when scanning the original formed of book-
let or when scanning an original by keeping ADF open.
Terms Explanation