JLG 10MSP Service Manual - Manual (Page 133)

SECTION 6 - TROUBLESHOOTING
3121228 – JLG Lift – 6-29
Code 30 - Traction Module - No Communication with Ground Control Module
Check For These Obvious Conditions First:
• Check if the communications cable connections, P5 connector on the Ground Control Module and round plug on the
Traction Control Module are seated properly in their sockets at each end.
• Check the Positive (+) (RED) and Negative (–) (BLACK) power cable connections from the Ground Control Module to the
Traction Control Module are tight and secure at both ends.
Table 6-29. Code 30 - Traction Module - No Communication with Ground Control Module
STEP ACTION SPEC YES NO
1. Check the voltage reading at the main power Positive (+)/Negative (–)
cable connection on the Traction Control Module. 24v DC Go to Step 2 Repair or Replace
Positive (+) or
Negative (–) Cable
2. Remove the communications cable, P5 connector at the Ground Control
Module and round connector at the Traction Control Module. Check conti-
nuity of all three (3) wires in the communications cable from end to end. P5
- Pins 2, 3, and 4. — Go to Step 3 Repair or Replace
Wire(s)
3. With communications cable disconnected at both ends, check for continu-
ity between Pins 2, 3, and 4 of the P5 connector end. — Repair or Replace
Wires
Go to Step 4
4. Plug the communications cable on the Traction Control Module to the round
socket on the opposite end of the module. Does this fix problem? — Done Replace Traction
Control Module
5. Unplug the P5 connector at the Ground Control Module. Check voltage
between pins 2 (– lead-in) and 5 (+ lead-in). Is voltage within spec. 4.5v DC Done Replace Ground
Control Module