JLG 10MSP Service Manual - Manual (Page 56)

SECTION 3 - BASE COMPONENTS
3-24 – JLG Lift – 3121228
Brush Carrier Assembly - Remove/Install
Brush Assembly - Remove/Install Tank Remove/Install
Brush Carrier Assembly - Remove/Install
1. Stator/Brush Carrier Screws (Pump Rear)
2. Stator/Brush Carrier Screws (Pump Front) (a) 3. Mark Brush Carrier Position on Motor Housing
4. Brush Carrier Assembly
NOTE: (a) Removed previously with motor cover disassembly (shown for reference only).
1
2
3
4
Brush Assembly - Remove/Install
1. Brush Assembly (a)
2. Brush Carrier Socket
3. Brush Tab Slot 4. Brush Terminal Screw
5. Brush Attach Terminal
NOTE: (a) Slide brush assembly into socket until tab is in slot at
rear of socket.
1
4
2
3
3
5
Tank - Remove/Install
• For reassembly reference, place a mark on tank and valve body.
1. Tank Assembly 3. O-Ring Seal (a)
2. Tank Screws (Qty. 4) 4. Reference Mark
Note: (a) Lubricate o-ring with clean hydraulic fluid before sliding
tank over during installation.
2
3
1
2