JLG 10MSP Service Manual - Manual (Page 62)

SECTION 3 - BASE COMPONENTS
3-30 – JLG Lift – 3121228
teries and connections are not faulty, and Fault 6 is
again displayed after interrupting AC power for at
least 10 seconds, the charger must be brought to a
qualified service depot.
Battery Charger Maintenance Information
1. Make sure charger connections to battery terminals
are tight and clean.
2. Do not expose charger to oil or to direct high pres-
sure water spraying when cleaning vehicle.
Battery Charger Check/Change Charging
Algorithm
The charger comes pre-loaded with nine algorithms for
various battery types as detailed in the table below. If your
specific battery is not listed, please contact JLG.
Each time AC power is applied with the battery pack NOT
CONNECTED, the charger enters an algorithm select/dis-
play mode for approximately 11 seconds.
Repeat until desired Algorithm # is displayed. A 30 sec-
ond time-out is extended for every increment.
During this time, the current Algorithm # is indicated on
the YELLOW ‘CHARGING’ LED. A single digit Algorithm #
is indicated by the number of blinks separated by a
pause. A two digit Algorithm # is indicated by the number
of blinks for the first digit followed by a short pause, then
the number of blinks for the second digit followed by a
longer pause.
To check/change the charging algorithm:
1. Disconnect the charger positive connector from bat-
tery pack. Apply AC power and after the LED test,
the Algorithm # will display for 11 seconds.
2. To change algorithm, touch connector during the 11
second display period to the battery pack’s positive
terminal for 3 seconds and then remove – the Algo-
rithm # will advance after 3 seconds. Repeat until
desired Algorithm # is displayed. A 30 second time-
out is extended for every increment. Incrementing
beyond last Algorithm moves back to first Algorithm.
After desired Algorithm # is displayed, touch the
charger connector to the battery positive until the
output relay is heard to click (~10 seconds) – algo-
rithm is now in permanent memory.
3. Remove AC power from the charger and reconnect
the charger positive connector to the battery pack. It
is highly recommended to check a newly changed
algorithm by repeating the above steps 1) and 3).
ALGORITHM
SETTING
BATTERY TYPE
1 Trojan T105
2 Trojan T105 Tapped
3 T105 DV/DT CP
4 US Battery USB2200
5 Trojan 30/31XHS
6 DEKA 8G31 Gel
7 J305 DV/DT CP
8 Concorde 10xAH AGM
23 Douglas AGM Flooded (Default)
43 US AGM 6V27 (210AH)