Hub - disassembly, Hub - disassembly -13 – JLG 10MSP Service Manual User Manual

Page 45

Advertising
background image

SECTION 3 - BASE COMPONENTS

3121228

– JLG Lift –

3-13

Hub - Disassembly

1. Remove Main Wheel Bearing (G14).

NOTE: This part is held in the hub with a press fit. To remove have

the hub setting seal side up. Use a plate or rod with a large
enough diameter push in the inner race of the bearing. Apply
force to the push the bearing out. This bearing will need to
be replaced upon reassembly.

2. Remove main Lip Seal (G16).

NOTE: This Lip Seal (G16) is also held in with a press fit. Remove

the Lip Seal only if the hub or seal needs to be replaced. The
Lip Seal will most likely become damaged during removal.
Try not to damage the hub bore.

Hub Disassembly

Advertising