JLG 10MSP Service Manual - Manual (Page 15)

SECTION 1 - MACHINE SPECIFICATIONS
3121228 – JLG Lift – 1-3
Machine Height
Platform Elevated - 13.74 ft. (4.19m)(Top of platform rails)
Platform Stowed - 57 in. (1.44m)
Machine Overall
Length - 61 in. (1.55m)
Width - 29.5 in. (75cm) standard
32.5 in. (82.5cm) with bumpers
35.0 in. (89cm) with roller guides
Platform Entry Height (Floor to Platform Floor)
13.75 in. (34.9cm)
Machine Ground Clearance
Front - 0.872 in. (22mm)
Center - 1.872 in. (47.5mm)
Rear - 0.622 in. (16mm)
Machine Turning Radius (Outside)
106 in. (269cm)
1.4 TORQUE REQUIREMENTS
When maintenance becomes necessary or a fastener has
loosened, refer to the applicable Torque Chart in this sec-
tion of the manual to determine proper torque values for
various size fasteners.
1.5 CYLINDER SPECIFICATIONS
NOTE: All dimensions are given in inches (in), with the met-
ric equivalent, centimeters (cm), given in parenthe-
ses.
1.6 SERIAL NUMBER LOCATIONS
For machine identification, a serial number plate is affixed
to the machine. The plate is mounted on the base frame
between the front caster wheels under the front cover. The
serial number is also stamped on the front of the mast
assembly near the amber beacon.
1.7 LUBRICATION
Hydraulic Oil
Hydraulic oils must have anti-wear qualities at least to API
Service Classification GL-3, and sufficient chemical stabil-
ity for mobile hydraulic system service. JLG Industries,
recommends Mobilfluid 424 hydraulic oil, which has an
SAE viscosity of 10W-30 and a viscosity index of 152.
For cold weather applications, i.e. when temperatures
remain consistently below +20°F (–7°C) JLG recom-
mends using Mobil DTE 13 hydraulic oil.
Aside from JLG recommendations, it is not advisable to
mix oils of different brands or types, as they may not con-
tain the same required additives or be of comparable vis-
cosities. If use of hydraulic oil other than Mobilfluid 424 is
desired, contact JLG Industries for proper recommenda-
tions.
Lubrication Specifications
Table 1-3. Cylinder Specifications
DESCRIPTION
BORE
in./(cm)
STROKE
in./(cm)
ROD DIA.
in./(cm)
10MSP -
Lift Cylinder 1.63
(4.10)
41.50
(105.4)
1.375
(3.49)
Table 1-4. Hydraulic Oil Operating Range
HYDRAULIC SYSTEM OPERATING
TEMPERATURE RANGE
SAE VISCOSITY
GRADE
+0° F to +180° F
(-18° C to +83° C)
10W
+0° F to +210° F
(-18° C to +99° C)
10W-20, 10W-30
+50° F to +210° F
(+10° C to +99° C)
20W-20
Table 1-5. Lubrication Specifications
KEY SPECIFICATIONS
MPG - Multipurpose Grease having a minimum dripping
point of 350° F. Excellent water resistance and
adhesive qualities, and being of extreme pressure
type. (Timken OK 40 pounds minimum.)
EPGL - Extreme Pressure Gear Lube (oil) meeting API ser-
vice classification GL-5 or MIL-Spec MIL-L-2105.
HO - Hydraulic Oil. ISO-Vg grade 32, 46.
CL - Chain Lube. Use a good quality chain lubricant