Rear bumper cover - installation, Drive motor cover - installation – JLG 10MSP Service Manual User Manual
Page 35
SECTION 3 - BASE COMPONENTS
3121228
– JLG Lift –
3-3
Rear Bumper Cover - Installation
Five (5) of the Drive Motor cover screws must be removed
to remove the rear bumper cover, see the Drive Motor
Cover - Installation illustration. To gain access to those
screws, elevate the platform.
Drive Motor Cover - Installation
NEVER WORK UNDER AN ELEVATED PLATFORM UNTIL THE
PLATFORM HAS BEEN SAFELY RESTRAINED FROM ANY MOVE-
MENT BY BLOCKING OR OVERHEAD SLING.
To gain access to the drive motor cover and screws, ele-
vate the platform.
Rear Bumper Cover Installation
1. Bumper Cover
2. Screws/Washers
3. AC Input - Receptacle
Assembly Cover
Drive Motor Cover Installation
1. Cover
2. Screws/Washers (a)
3. Platform Stop (a) (b)
4. U-Style Tapped Nuts
NOTE: (a) Apply Loctite #242 to threads before tightening.
(b) Height of the platform stops is set by installing two
(2) 5/16" dia. wide plain steel flatwashers under the head
of each stop, tighten securely.