JLG 10MSP Service Manual - Manual (Page 85)

SECTION 5 - MAST COMPONENTS
3121228 – JLG Lift – 5-3
5.4 MATERIAL TRAY - INSTALL/REMOVE 5.5 PLATFORM - 7 FT. HEIGHT LIMIT
SWITCH - OPTION
Material Tray Installation
1. Material Tray Assembly
2. Tray Bottom Stops (b) 3. Tray Release Bar (c)
4. Raise Platform (a)
Note: (a) Raise the platform approximately 2 ft. (60cm) when
sliding the tray off the bottom of the mounting rails. Tray
will not clear beacon or hood without raising platform.
(b) Remove stops to slide tray off the bottom of the mount-
ing rails.
(c) Once bottom stops are removed carefully lower the tray
to bottom and slide off of the mounting rails and move
clear of machine. If tray is allowed to drop with stops
removed damage to the amber beacon and hood could
occur.
1
2
3
4
Platform - 7 Ft. Height Limit Switch (OPTION) - Installation
1. Mast - Front of Machine
2. Mast - Platform Side 3. Proximity Switch/Bracket
and Fasteners
4. Switch Detection Plate
While the standard maximum platform height for this
machine is 10 ft., this option limits platform height to 7
ft. for certain applications.
NOTE: Route the proximity switch wire with mast junction
box wiring harness, attach with tie straps.
Proximity switch wire connects to AUX 2 input on
the main harness.
The ground control module AUX 2 setting must
be programmed to "HIGH", and the AUX 2
INHIBIT setting must be set to "0" (See Section
4.4, Ground Control Module - Programming).