JLG 10MSP Service Manual - Manual (Page 44)

SECTION 3 - BASE COMPONENTS
3-12 – JLG Lift – 3121228
Input Carrier Disassembly
1. Remove Retaining Rings (G18) from each of the
three Planet Shafts (G6).
NOTE: Do not overstress these Retaining Rings when removing
them.
2. Remove Thrust Plate (G23).
3. Remove Thrust Washer (G25) from each Planet
Shaft (G6).
4. Slide each Input Planet Gear (G5) off the Planet
Shaft (G6).
5. Press out Bushing (G26) from the bore of each
Planet Gear (G5). Bushings cannot be reused
when removed.
6. Remove the other Thrust Washer (G25) from each
Planet Shaft (G6).
7. Remove Retaining Ring (G24) from Output Sun
Gear (G8).
8. Slide Output Sun Gear (G8) out from the center of
the Input Carrier (G7).
9. Remove the three Planet Shafts (G6) from the Input
Carrier.
NOTE: The Planet Shafts (G6) are held in with a press fit. To avoid
damage to the parts, use an arbor or hydraulic press to
remove the Planet Shafts (G6).
Input Carrier Disassembly