CHAMPION DH5000T Single Source Gas Manual - Manual (Page 102)

94
Installing the Condensate Removal Electrical Control Box
G
1/4-20
MOUNTING
BOLTS
H
MOUNTING
BRACKET
5. Locate the (4) 1/4-20 x 1/2" Hex
Head bolts on the upper left rear
side of the dishwasher directly
below the handle bracket
(Refer to Figure G).
6. Remove these bolts and set aside.
7. Carefully lift the electrical control
box and mounting bracket assembly
in place, align the mounting holes
and reinstall the mounting bolts
removed in Step 6 above.
(See Figure H below).
P/N 115107 - Condensate Removal Option Installation Instructions
(continued from previous page)
! ATTENTION !
The Condensate Removal Control Box connection diagram appears on page 99
of these instructions.
The control box connections were prewired at the factory.